Ping a loopback address3/21/2024 My guess is that this will successfully ping. Now you have controlled what the source IP is for the ping packet. So specify the IP address of one of the loopbacks on the EAST. Then hit Y and then it will ask you for the source ip address or interface Then take the defaults for everything UNTIL it says Extended Commands So make sure you select IP for the protocol and specify the correct target IP address. Then it will prompt you for several things. So from the EAST type ping and hit enter. If you were to try an extended ping I think you would have success. So now when the ping reaches the the loopback on the EAST it tries to return the packet destined to 172.16.124.3, but there is nothing in the frame relay map for. So when you ping the EAST loopback you are sourcing it with the 172.16.124.3 ip address. When you issue a ping command like you did from the router, the router uses the ip address of the outbound interface to source the ip packet. Sending 5, 100-byte ICMP Echos to 10.2.3.1, timeout is 2 seconds: Ia - IS-IS inter area, * - candidate default, U - per-user static route I - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2Į1 - OSPF external type 1, E2 - OSPF external type 2 The hub is HQ and spokes are EAST & WEST, I can't ping the loopback of router EAST from the router WEST and the reverse as well, the topology is like this:Ĭodes: C - connected, S - static, R - RIP, M - mobile, B - BGPĭ - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area Hello i have a problem with eigrp, i configured eigrp through a frame relay cloud, hub and spokes
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |